Maybe a solution...
Remote control no longer responding. Receiver or remote control command set may have been unintentionally changed Set infrared code 1, as described in operating manual under
“Remote Control RC 660”; check batteries.
Remote control RC 660
The RC 660 remote control supports up to four devices (supplied as
standard with the RC 660) as well as the receivers of the UFD 5xx
(not UFD 552, 554, 558) and UFD 4xx families.
First switch all receivers off at the power switch.
To configure a receiver to an infrared code:
Switch on the relevant receiver.
On the remote control simultaneously press
Address 1 = exit + 9 + 1
Then switch the receiver off again at the power switch and do the same
for the other units (exit + 9 + 2 for second receiver; exit + 9 + 3
for third receiver and exit + 9 + 4 for fourth receiver).
Make sure only one receiver is on at a time!
To switch the remote control to an infrared code:
When you have configured all receivers to their infrared code, to switch
between units on the remote control do the following:
For the first receiver’s remote (address 1) press exit + 1; for the
second receiver exit + 2; for the third receiver exit + 3; and for the
fourth receiver exit + 4.
|