Mam problem s bootovanim Dreamboxu. Chtel bych se zeptal, jestli neexistuje možnost opravy pres seriovy port nebo je jedinou moznosti opravdu jen JTAG(Proc?)? Pro jistotu pripojuji vypis, ktery dostanu na obrazovku pri pripojeni pres rs232, mozna tento problem souvisi s necim jinym a jen panikarim. Predem dekuji za radu.


SMSC: PHY AutoNegotiate timeout. Assume 10Mbps/half duplex
Booting from [ENET] Ethernet...
Sending bootp request ...
bootp packets sent = 2
BOOTP failed.
Network boot failed.
trying 3 (1)
Booting from [S1] Serial Port 1...

PLEASE NOTE: You must now...


a. Exit from terminal emulation mode

b. Modify the baud rate of your host session to 9600

c. Transmit a file to the target using kermit

d. Reset the host baud rate to 9600

e. Reenter terminal emulation mode

f. Hit enter to continue